Bloodhound's mark does not work if too much bleed is applied

I used the skill quite a bit in endgame, it worked as expected.
But ever since upgrading my damage quite a bit, the red bar starts to fill as expected, then starts to deplete rapidly (without stunning the boss), and the UI bugs out noticeably (there are many red "|" to left and right of the stagger bar)
Sometimes the red stagger bar is filled, but no stun occurs either.

Same here, Trying to inflict a stun with the mark seems to have an opposite effect

This is still an issue with high bleed damage

0.4.0b still an issue.
Seems that the "damage dealt by bleeding" variable that is updated every tick doesn't handle the difference over 32k (16 byte), so it overflows into negative?

"

agitoreiken#6585 wrote:

0.4.0b still an issue.
Seems that the "damage dealt by bleeding" variable that is updated every tick doesn't handle the difference over 32k (16 byte), so it overflows into negative?

The issue isn't overflowing, this also happens at low levels where you would never reach numbers out of range.

Stun is building up to full and never procs, and seems to also not proc until your bleeds expire or the mark expires and you hit them again.